Gorilla Glue is the best glue to use for fixing glasses lenses. However, it can be tricky how to remove gorilla glue from glasses lens without damaging them. Knowing your need, we have compiled here the best methods with detailed steps to do it right. Let’s check out the suggestions below:
Best Methods to Remove Gorilla Glue From Glasses Lenses
1. Citrus-based cleaner
Citrus-based cleaners are the best to use as they contain natural chemicals that can easily dissolve gorilla glue. They also have a pleasant smell and won’t harm your eyes if someone gets splashed in it.
Here’s how you use it:
- Just pour some of the cleaner onto a cotton pad or a paper towel,
- Rub on both sides of glasses lens gently until you see how to remove gorilla glue from glass lenses coming off.
- Do not scrub too hard because this might damage your glasses lens even more.
- Rinse with warm water after cleaning for at least 30 seconds each side.
2. Goggles and blow dryer
- Wear the goggle on your head, then turn on low heat of the blow dryer directly onto glasses lens for about 30 seconds each side or until it comes off easily.
- You may need another clean cotton pad/paper towel if there are still residues left behind after cleaning.
- Rinse under warm water for half minute per side afterwards.
3. Apply ice pack
If you don’t have Citrus-based cleaner, goggles, or a blow dryer at hand, how about using an ice pack? This method is not as quick as the other methods above but it’s simple and safe. You will need some cotton pads/paper towels or even better – microfiber cloths (you can get them in any big grocery store)
- Just apply onto your glasses with either paper towel or clean microfiber cloth
- Press gently on top of that with cold ice pack for 30 seconds each side.
- Make sure you avoid applying too much pressure because this might crack your glasses lenses further.
- Let it sit there until how to take off gorilla glue from glasses lens are completely dry.
- Rinse under warm water afterwards for half minute per side, then check how to remove gorilla glue from glass lenses if it is clean enough with your bare eyes.
- If not, repeat the process until you see how to eliminate dried gorilla glue on glasses lens coming off easily.
4. Hot water with dish soap
Hot water is another way to remove gorilla glue from glasses lens method that you can try.
Just make sure the temperature of the hot water isn’t too high or it might damage your lenses even more. You will also need dish soap, vinegar, and definitely goggles for safety purposes. Now let’s do this:
- Mix some dish soap and pour this solution into a large bowl (make sure it’s big enough) containing how to take off with warm water.
- Dip your glasses lens in there for about 30 seconds each side until how to get rid of gorilla glue comes off easily;
- Rinse under tap water afterwards if needed – do not scrub at all!
5. WD-40
Removing gorilla glue from glasses lens with WD-40 is easy and safe. Plus how to get rid of gorilla glue fast can be done without damaging your lenses; how about that!
You will need cotton pads (or paper towel), some water, dishwashing liquid, and cloth for this method as well:
- Put off on one side of the glasses then spray it with WD-40 onto another side or all over the surface
- Avoid getting too close though because you might damage your eyesight if any splash goes into them!
- Let it sit there for 20 minutes at least
- For the residues left behind afterwards using warm and dishwashing liquid then scrub
6. Contact Lenscrafters for their professional lens cleaning service!
The mentioned methods are not guaranteed to work 100% of time! Please do not attempt this at home if you have no prior experience with removing Gorilla Glue from glass surfaces!
Therefore, if all fail, It’s the best choice to Contact Lenscrafters for their professional lens cleaning service if you want your lenses cleaned without harming them at all! You can also get your glasses done by their technicians.
Conclusion
Gorilla Glue can be removed from glass lenses with patience and persistence. This blog post has given you some of the best methods to remove gorilla glue from your glasses, so now it’s time for you to put them into action!
Frequently Asked Questions
What solvents dissolve Gorilla Glue?
To dissolve Gorilla glue, mix it with a solution of acetone and water. The mixture should be around 50% water and 50% acetone, to begin with, then add more water as necessary to make the solution pourable.
One popular technique uses detergent to dissolve the excess particles that accumulate during drying. This can take a few hours depending on the adhesive’s type and its thickness. Another common technique is immersing the resin-based glue in warm or boiling water once again, which will often result in an easier removal process than when using room temperature.
How do you get super glue off plastic eyeglasses?
There are a few approaches to removing super glue. One is to use Vaseline or olive oil, which causes the glue to soften and can be easily peeled off of the sunglasses. Another way is applying hair straightener on first for 5 minutes, then using normal soap or alcohol on first until all the compound has been removed, followed by nail polish remover on second for ten minutes.
An extremely effective technique is microwaving excess adhesive for 30 seconds at a time until it’s no longer sticky – it can usually be immediately peeled away! While this method doesn’t work with some hard plastics, some people have found that heating plastic sunglasses in this way has actually made them more durable.
Does toothpaste remove super glue?
No.
Toothpaste is made of sodium lauryl sulphate and other additives that are too large for most molecules of super glue to dissolve in. It is likely that you’ll require a solvent such as acetone, methyl ethyl ketone, or xylene to dissolve the glue. This can be done by adding them directly to the super glued material and letting the mixture soak for 10-20 minutes before rubbing it until it’s loose and liquid. You may also need to scrub with a toothbrush. As always, consult an expert before damaging any object for this purpose.
Can vinegar remove super glue?
The answer to this question is not really qualitative or exact, for many people who have tried it found that vinegar did not work at all. However, if you need an adhesive remover, there are other products on the market which are specifically designed for this purpose.
The reason vinegar doesn’t effectively remove super glue has to do with its chemistry. The acetic acid in vinegar reacts chemically with polymers in many plastics including super glue’s backing plastic film. But the acetic acid only attacks PPAs (polyacrylic acids) in superglue because they are compatible with one another at a molecular level whereas PVA (polyvinyl alcohol), the main polymer in most other adhesives, do not react well with them
How do I remove Gorilla Glue Spray adhesive?
It is possible to remove Gorilla Glue Spray adhesive, but it can be very time-consuming. Start by applying some heat with a blow dryer which will soften the glue and make it easier to scrape off. Next, use a thick layer of petroleum jelly or cooking oil on top of the epoxy residue, cover with plastic wrap and allow the mixture to soak for an hour or so. After that, remove the plastic wrap and start scraping away at the adhesive until gone. You may need to repeat these steps many times before all of your glue is removed.